New RB2060!!!!!

Picked up my new RB2060 blade after work today!!!:yahoo:
I'll get some picks on here maybe tonight. I could have waited to post this until I had the pictures taken, but I had an extra minute and couldn't wait to tell everybody! :laugh:
One thing I was afraid of though. When I got home with it I backed on the trailer and hooked it up to unload it but I don't have enough height to drive off the trailer with gate. I haven't tried pulling on yet but I'm guessing it may not work either. The only reason I think it might work is the back of the trailer squats down pretty far when pulling it on. It maybe just enough to work.

My other thought is the lift arms that that pull up the lower 3pt hitch arms have an extra hole above where the are pinned on currently. The hole is smaller but I thought I could drill it out to the correct size and and lower the lift arms to those holes. Which should give me several more inches of lift. The only problem I for see with this in the top link might raise to high and hit the back fender under the seat.

What are your thoughts?