hey guys.. for those of you that are aware of my rear axle seal replacement thread, you'll understand why I'm going after another small problem I have.. Not a big deal, but I do have some hydro fluid coming out of either the cylinder itself or the hoses that go into and come out of the cylinder are leaking.. Is there supposed to be any kind of a washer inside the threads of the nut/coupler (not sure what its actually called) at the end of the lines where they connect to the cylinder?.. Figure I'll start there since it would be simplest fix if the leak is right at the connection to the cylinder.. How likely is it that the cylinder itself is leaking?.. I've never been able to pin point exactly where the leak is coming from.. The connections are just always wet and I get a few drops of hydro fluid on the floor after every use.. Is it difficult to remove the cylinder itself if its leaking?.. Thanks!..
↧
