Added lights and guards to my 1025

I have needed some lights higher up on my 1025 so I can see past my loader at night. I lowered the existing tail and flasher lights as much as I could without interfering with the factory tool box for clearance when the ROPS is folded down. I have the TLB setup so the tool box kept the lights a little higher than I would have liked.

I added 1/4 steel guards for the lights we made at work and an implement light on a separate also. It sure lights up the dark now and I can even see where I am going! The factory brackets on my 1025 made it easy to move them down and no new holes were drilled in the ROPS.

I still want to clean up some wiring on it.

image.jpg
image.jpg
image.jpg
image.jpg

Attached Images

• image.jpg (1.72 MB)
• image.jpg (1.38 MB)
• image.jpg (1.55 MB)
• image.jpg (1.55 MB)
• image.jpg (1.61 MB)
• image.jpg (1.58 MB)