I've got a JD 100 Series Model 125 Automatic, as seen in the attached picture, however the Pedals (Forward/Reverse) are Reversed. The tractor runs fine, as far as I can tell (may not get quite the speed I've seen from others, possibly due to this modification), I just have to use the pedals, opposite as designed. The Forward Pedal has been modified for Reverse and the Bottom Pedal on the Deck has been modified for Forward. Not sure why the previous owner did this, perhaps easier on his leg to put his foot on the deck rather than compressing the forward pedal for an extended time?
2.jpg
With that said, I'd like to restore this configuration to the factory defaults. Is this something that can be done? Thoughts on where I can look to see where the modification was made and where I can reverse the changes made? Thoughts on anything else I should check as well?
Thanks
2.jpg
With that said, I'd like to restore this configuration to the factory defaults. Is this something that can be done? Thoughts on where I can look to see where the modification was made and where I can reverse the changes made? Thoughts on anything else I should check as well?
Thanks