Hello all,
I recently acquired an 2001 JD F725, serial # 110187
I've encountered a failure today, it appears that the pulley
Broke free from the pto clutch :-(
As I was prepping to remove the pto, I for the life of me
Cannot figure out how to hold the shaft to break the bolt free.
Normally the washer would have two flats or there would be a wrench
Access somewhere, but I cannot locate it.
I could use some guidance on this.
As a second question, had anyone recently purchased a
New pto clutch for less than $350, if so, where if you don't mind sharing.
Thank You
I recently acquired an 2001 JD F725, serial # 110187
I've encountered a failure today, it appears that the pulley
Broke free from the pto clutch :-(
As I was prepping to remove the pto, I for the life of me
Cannot figure out how to hold the shaft to break the bolt free.
Normally the washer would have two flats or there would be a wrench
Access somewhere, but I cannot locate it.
I could use some guidance on this.
As a second question, had anyone recently purchased a
New pto clutch for less than $350, if so, where if you don't mind sharing.
Thank You