Hi, I introduced myself in the newbie section and now I am here because I need of some help. I have had this 4410 since last fall and it has been a life saver. I only had 200 hrs when I purchased it and was babied its whole life and looked brand new. We could not live in our home without it because of the snow, terrain and the driveway. I was using it on Saturday doing some back blading on a gentle slope and my reverse stopped working. After that happened, then it would not go forward. I shut it off and turned it back on and it went forward, but not reverse and when I tried, then it would not go forward either. I shut if off again and restarted and drove it back to the barn. All levels look good except the front axle seemed a little low. When I opened it there was a vacuum sound as I opened it. I added a quart, but I am having a hard time reading that stick as it seems there is oil on it, but I cannot read a level. As far as codes, I am getting 1 quick flash, then 3 slow ones when this happens. I am hopeful it is not serious, but need you seasoned Deere owners advice. Thank you...Steve
↧