This weekend I borrower my son in law's Frontier PHD 300 post hole digger to use on my 2720. It worked very well, except that I could only drill about 30" deep with it. The 3 point hitch on my 2720 does not go low enough to be able to dig deeper than that.
I was needing to go over 36" deep. I was able to dig deeper holes by using the loader to raise the front of the tractor off of the ground, but that was a pain to do on each of the 27 holes that I drilled.
On the 2320, that I traded for the 2720, the 3 point hitch lift links had 3 different positions to set the draft link height. The 2720 only has one height position on the lift arms.
Anyone know if the lift arms from the 2320 will work on a 2720?
![]()
I was needing to go over 36" deep. I was able to dig deeper holes by using the loader to raise the front of the tractor off of the ground, but that was a pain to do on each of the 27 holes that I drilled.
On the 2320, that I traded for the 2720, the 3 point hitch lift links had 3 different positions to set the draft link height. The 2720 only has one height position on the lift arms.
Anyone know if the lift arms from the 2320 will work on a 2720?
