I would like to know how to remove and replace the main drive belt, from the engine to the hydrostatic pump pulley.
The belt transitions from a horizontal pulley on the engine to a vertical pulley near the rear axle.
There is not enough slack in the belt to get it off the pump pulley with the plastic fan in place.
There is no room available to remove the fan, as it is close to the frame.
Hopefully the new belt will fit between the fan and the frame.
Is it easy to remove the PTO clutch off the bottom of the engine shaft?
Thanks.
The belt transitions from a horizontal pulley on the engine to a vertical pulley near the rear axle.
There is not enough slack in the belt to get it off the pump pulley with the plastic fan in place.
There is no room available to remove the fan, as it is close to the frame.
Hopefully the new belt will fit between the fan and the frame.
Is it easy to remove the PTO clutch off the bottom of the engine shaft?
Thanks.