The "heads up" is: (I meant to post this way earlier... I forgot!) If you are removing the cover for the operating levers, Uncle Manual sez to "remove 4 bolts" and shows one of them in a photo. ONLY THE 2 TOP ½" BOLTS hold the lever cover on, the others hold the lever/valve assembly to the permanent cover plate and BH frame. IF you try the other bolts they will loosen about ½ a turn and just spin... Once you get the cover off you'll need to hold the backing nuts with a wrench and resecure the "non-cover valve body bolts" again. AMHIK!:laugh:
QUESTION: What is the single lonely "Mystery Zerk Fitting" that appears on the BH valve body right by the RH stabilizer lever? It has no references in the Operator's Manual, and there's only one... I wanted to, I really really did, I wanted to shoot some grease in it, but I held off until I know where that grease is going.
QUESTION: What is the single lonely "Mystery Zerk Fitting" that appears on the BH valve body right by the RH stabilizer lever? It has no references in the Operator's Manual, and there's only one... I wanted to, I really really did, I wanted to shoot some grease in it, but I held off until I know where that grease is going.