Just received phone call from dealer he has a new valve for the FBS on fel. New dash, today while mowing and it was raining it showed moisture inside.
Noticed a slight leak , a few drops of oil around the mm pto shaft so dealer will order new seal so it will be there next week.
The final item , lift cylinder for bh support arm has a small leak so taking it with me for dealer to repair.
Taking tractor to dealer on Monday and hoping to get it back by Thursday .
Tired of pulling over mower deck , it moves then ,pulling or trying to push mower to get it connected. Been removing mower in shed that has a 1/2" rubber pad. The other evening ,had a hammer drill in my hand doing another job ,thought why not drill two holes in the concrete floor .
In the front of the mower , just beside the front wheels drilled a hole on each side of mower.
Put a 1/2" bolt 4" long in hole, pulled up over deck , deck moved maybe a 1/4" heard "click". Installed .
Reason for putting bolts out toward the outer part of mower instead of in front thought maybe the front wheels would hit while trying to install.
Plus I can leave bolts in floor if I want to and still pull tractor in shed.
When not needing pins I can put a shorted bolt in hole and keep holes clean for times needed to install deck.
Noticed a slight leak , a few drops of oil around the mm pto shaft so dealer will order new seal so it will be there next week.
The final item , lift cylinder for bh support arm has a small leak so taking it with me for dealer to repair.
Taking tractor to dealer on Monday and hoping to get it back by Thursday .
Tired of pulling over mower deck , it moves then ,pulling or trying to push mower to get it connected. Been removing mower in shed that has a 1/2" rubber pad. The other evening ,had a hammer drill in my hand doing another job ,thought why not drill two holes in the concrete floor .
In the front of the mower , just beside the front wheels drilled a hole on each side of mower.
Put a 1/2" bolt 4" long in hole, pulled up over deck , deck moved maybe a 1/4" heard "click". Installed .
Reason for putting bolts out toward the outer part of mower instead of in front thought maybe the front wheels would hit while trying to install.
Plus I can leave bolts in floor if I want to and still pull tractor in shed.
When not needing pins I can put a shorted bolt in hole and keep holes clean for times needed to install deck.