I have a 2010 3720 with 300cx FEL with 400 hours on it. The curl cylinders allow the curl to drop almost all the way down in about 1-2 seconds. I ordered 2 cylinder repair kits hoping installing them will fix that problem.
My problem is, I never had them apart and don't have a technical manual to tell me how to do that. I know it's like opening a coconut but was hoping someone here could give me some advice other than take it to a dealer or but new cylinders at $600 a piece.
Of course I plan on taking the cross shaft off to try to see which cylinder is bad or worse. That is a start for me.
Any suggestions, please.
Chuck
My problem is, I never had them apart and don't have a technical manual to tell me how to do that. I know it's like opening a coconut but was hoping someone here could give me some advice other than take it to a dealer or but new cylinders at $600 a piece.
Of course I plan on taking the cross shaft off to try to see which cylinder is bad or worse. That is a start for me.
Any suggestions, please.
Chuck